Blasting & Painting

SSPC-spec surface preparation and industrial coating in a controlled-environment booth — from SP-6 commercial to SP-10 near-white, primed and topcoated to your data sheet.

Request a Quote

View Capabilities →

Blast Booth Length

Booth Width

Booth Height

Coats Standard

Blasting & Painting at Steel Effects.

A single-source paint shop on the same floor as our fab means parts move from weld-out to crate with minimal handling. We hold surface profile to your data sheet, prime within the recoat window, and topcoat in a clean, climate-stable booth.

What we work with

Steel grit and aluminum oxide abrasives

Zinc-rich primers (organic & inorganic)

Epoxy and urethane systems

High-temp silicone coatings

Customer-specified specialty paints

Capabilities

Process	Capacity	Material	Best For
SP-6 Commercial Blast	Standard	Indoor & sheltered service	Most general fab
SP-10 Near-White	Premium	Aggressive service	Offshore, refinery, marine
SP-5 White Metal	Maximum	Immersion / extreme	Tank linings, critical service
SP-WJ Water Jetting	On request	Sensitive substrates	Recoat & repair

How we run the job

Step 01

Inspect

Substrate is reviewed for contamination, rust grade, and existing coating.

Step 02

Blast

Abrasive blast to the specified SSPC standard and profile.

Step 03

Prime

Primer applied within the recoat window — film thickness logged.

Step 04

Topcoat

Mid and topcoats applied to data-sheet DFT in the booth.

Quality & traceability

Every job is documented to the same ISO-aligned standard that runs across our floor — heat numbers transferred, procedures qualified, and inspection signed off before parts leave the dock.

ISO-aligned quality management system

Material test reports (MTRs) supplied with every shipment

Procedure qualifications matched to your code requirement

First-article and in-process inspection records on file